h1

Configure an ATA

Configure an ATA

you need a vcall user name & password for this service

STEP 1
You must first determine what IP address it received. To do this, you need to pick up the phone attached to the Line 1 jack and

dial:   **** (four asterisks)
then dial: 110 #
and you will be told the IP address of your device (e.g. 192.168.0.100).

STEP 2
Go to any browser equipped computer on your network and enter the address:

http://<IP ADDRESS>/

(where <IP ADDRESS> is replaced by the address that was given to you in STEP 1.

STEP 3
Click on the “Admin Login” button near the top right side of the screen, then click on the “Line 1″ tab.

STEP 4
You need to modify only a few parameters from the factory default. They are listed here:
PROXY AND REGISTRATION
Setting Value
Proxy 69.12.21.252
Outbound Proxy 69.12.21.252
Use Outbound Proxy YES

Register Expires: 300

SUBSCRIBER INFORMATION
Setting Value
Display Name Your Account No.
User ID Your Account No.
Password Your Account Password
AUDIO CONFIGURATION
Setting Value
Preferred Codec G729a

STEP 5
Click on the “Save Settings ” button at the bottom of the form.

STEP 6
Make calls!

ATA Wiring Video

[youtube=http://www.youtube.com/watch?v=0wP0uZDFa-U]